In these section i have to do lots of 360 view paning to get the right shape molding meshes into proper required frontal design.  Front and rear have almost the same basic stretched "X" marking on the center structure.  But i have to make it looks more beefy, tough and rigid looking.   I'm planing to raise the nose high a bit to make it looks typical truck looks and the hood to be more plain, spacy and wide. The roof also one of the main concern because it looks very soft and not able to match the front hood and nose design.  I'll try to see how i could get around with the construction.  Tomorrow is Saturday, i hope i have more to work more on VEXUVIUS,  i think right now we are at 30% away from total model completion.